![]() Now, Weaver rails can be found in both one-piece and two-piece variants depending on your preferences and needs. This two-piece design allowed the bolt opening to be free from obstructions, allowing cartridges to be inserted easily and for the use of stripper clips. One piece would go on the front of the receiver and the other would attach to the rear for scope mounting. The Weaver rail came before the Picatinny.Īdditionally, when Weaver rails were introduced, they were made in two separate pieces. ![]() The founder, William Ralph Weaver, also designed the Weaver rail as a mounting system for his scopes. Weaver Optics has produced scopes for decades. The difference between Weaver and Picatinny Rails is fairly minute, so if you are capable with a Dremel or file you may be able to make Picatinny devices fit on a Weaver rail. If the scope has been supplied with Picatinny-style rings, you will most likely be limited to only the Picatinny mount. So those Weaver-style rings that came with your new scope will work on both styles of rails. The Picatinny rail has a slot width of 0.206″ (5.232 mm) and the spacing of slot centers is always 0.394″ (10.008 mm).īecause of this, Weaver devices will fit on Picatinny rails, but Picatinny devices will not always fit on Weaver rails. Weaver rails have a slot width of 0.180″ (4.572 mm), but are not necessarily consistent in the spacing of slot centers. The main differences between the Weaver and the Picatinny rails are the size of the cross slots and the slot spacing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |